Category: 3D Printing
-

KRAFTPROTZ 3D Printing Glue Review: Fixing a Broken PLA-CF Print
My take: It works, but hold the part for about two and a half minutes before you let go. Disclosure: I bought…
-

40-Roll Filament Dry Cabinet Review: Easy Build, Printer on Top
My take: Easy to build in about half an hour. If you’re serious about printing, you’ll need one of these soon. Disclosure:…
-

eSUN PETG-HS Review: Great Once You Dry It
My take: Highly recommended, once you dry it and dial in the temps. I tested eSUN PETG-HS high-speed PETG. My first prints…
-

Magigoo Review: Bed Adhesive That Stops Prints Flying Off
My take: Very good stuff. My early failures were my settings, not the Magigoo. Disclosure: Magigoo sent me this as a free…
-

Creality Space Pi SE Filament Dryer Review: PETG at 50C
My take: My filament dryer of choice, with a humidity meter that makes the drying easy to watch. I loaded PETG, set…
-

This Glue Saves Broken 3D Prints in Seconds
My take: A quick dab of this glue and your broken 3D print is back in one piece — no reprinting required.…
-

Flush-Cut Wire Cutters Review: 5-Pack for 3D Printing and Hobby Work
My take: Sharp, comfortable flush cutters, and with five of them one goes in every drawer. Disclosure: Sunlink sent me these as…
-

The 3D Printer Tool Kit I’m Keeping
My take: the KENWQZI 70-piece kit puts everything you need to keep a 3D printer in good shape in one case. It’s…
-

The Centauri Carbon Hot End Swap That Finally Worked
My take: the second replacement hot end I bought for the Elegoo Centauri Carbon is the one I’d buy again. The first…
-

Elegoo PLA-CF: Great Prints if You Baby It
My take: Elegoo PLA-CF prints strong, hard, precise parts. It only performs if you keep it bone dry and dial in your…